Ubuntu20下C/C++编程开启TCP KeepAlive

本文主要是介绍Ubuntu20下C/C++编程开启TCP KeepAlive，希望对大家解决编程问题提供一定的参考价值，需要的开发者们随着小编来一起学习吧！

1、在linux下，测试tcp保活，可以使用tcp自带keepalive功能。

2、几个重要参数：

tcp_keepalive_time：对端在指定时间内没有数据传输，则向对端发送一个keepalive packet，单位：秒
tcp_keepalive_intvl：向对端发送了一个keepalive packet,如果对端无响应，则等待tcp_keepalive_intvl秒后再次发送一个keepalive packet
tcp_keepalive_probes：向对端发送一个keepalive packet，如果对端没有响应，重发的次数,如果tcp_keepalive_probes次数后，对端都可以响应，则表示这个socket已经断开，本地可以可以关闭这个socket上连接。

3、修改三个参数的系统默认值

上述三个参数当前配置可以在 /proc/sys/net/ipv4查看

可以使用cat查看具体配置，比如

全局设置:可更改/etc/sysctl.conf,加上:

sudo vim /etc/sysctl.conf

net.ipv4.tcp_keepalive_intvl = 20
net.ipv4.tcp_keepalive_probes = 3
net.ipv4.tcp_keepalive_time = 60

保存：wq

重启系统：sudo reboot

4、编程设置keeepalive:

#include <netinet/tcp.h>/*开始设置保活机制*/int val = 1;if (setsockopt(nc->sock, SOL_SOCKET, SO_KEEPALIVE, &val, sizeof val) != 0)
{perror("Set SO_KEEPALIVE fail");}/* Default settings are more or less garbage, with the keepalive time* set to 7200 by default on Linux. Modify settings to make the feature* actually useful. *//* Send first probe after interval. */val = 10;if (setsockopt(nc->sock, IPPROTO_TCP, TCP_KEEPIDLE, &val, sizeof(val)) < 0)
{perror("Set TCP_KEEPIDLE fail");}/* Send next probes after the specified interval. Note that we set the* delay as interval / 3, as we send three probes before detecting* an error (see the next setsockopt call). */val = 3;if (setsockopt(nc->sock, IPPROTO_TCP, TCP_KEEPINTVL, &val, sizeof(val)) < 0)
{perror("Set TCP_KEEPINTVL fail");}/* Consider the socket in error state after three we send three ACK* probes without getting a reply. */val = 3;if (setsockopt(nc->sock, IPPROTO_TCP, TCP_KEEPCNT, &val, sizeof(val)) < 0)
{perror("Set TCP_KEEPCNT fail");}

5、查看通讯情况，打开wireshark,在过滤器输入设置keepalive的Ip格式为：ip.addr==xxx.xxx.xxx.xxx