本文主要是介绍AWS linux挂载新的EBS，希望对大家解决编程问题提供一定的参考价值，需要的开发者们随着小编来一起学习吧！
1.在AWS控制台创建一个EBS卷,创建的EBS卷必须和将要挂载的EC2处于同一个可用区.并且挂载时EC2必须处于关机状态
2.两EBS卷连接至EC2,注意:连接时会提示 :注意:较新的 Linux 内核可能会在内部将您的设备重命名为 /dev/xvdf through /dev/xvdp，即使在此处输入的（并且在详细信息中显示的）设备名为 /dev/sdf through /dev/sdp。(这里的重命名就是你在linux中需要挂载的名称)
3.启动ec2并连接,fdisk -l命令:
[ec2-user@ip-172-31-14-69 ~]$ sudo fdisk -l
WARNING: fdisk GPT support is currently new, and therefore in an experimental phase. Use at your own discretion.Disk /dev/xvda: 8589 MB, 8589934592 bytes, 16777216 sectors
Units = sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disk label type: gpt# Start End Size Type Name
1 4096 16777182 8G Linux filesyste Linux
128 2048 4095 1M BIOS boot parti BIOS Boot PartitionDisk /dev/xvdf: 536.9 GB, 536870912000 bytes, 1048576000 sectors
Units = sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytesDisk /dev/mapper/docker-202:1-394826-pool: 107.4 GB, 107374182400 bytes, 209715200 sectors
Units = sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 65536 bytes / 65536 bytes
这篇关于AWS linux挂载新的EBS的文章就介绍到这儿，希望我们推荐的文章对编程师们有所帮助！
